26
AFTER SALES SUPPORT
1300 855 831
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Attachment and operation
4.
Assemble and disassemble the Grass trimmer (Nylon cutting head) (8). (Fig. 8-9)
To Release the nut (J).
• Line up the two holes of inner flange (G) and shield (K), use one screw driver to hold
the inner flange (G) as shown and turn the nut (J) clockwise, the nut will be re-
leased.
To Fit the Nylon cutting head.
• Remove cover cap (I). Still holding the inner flange (G) and outer flange (H), place
the Nylon cutting head on the shaft and rotate anti-clockwise, the Nylon cutting
head is fitted.
To Release the Nylon cutting head.
• Use screw driver to hold inner flange (G) and then rotate the Nylon cutting head
clockwise, it will be released.
5.
Assemble and disassemble the Cutting blade (Brush cutter) (27). (Fig. 10-12)
To Fit the Cutting blade (Brush cutter) (27).
• Take the outer flange (H) and cover cap (I) off after releasing the nut (J), then place
the Cutting blade (Brush cutter) (27), outer flange (H), cover cap (I) and nut (J) accord-
ing to priority as shown in picture. Please note the direction of rotation of the Cutting
blade (Brush cutter) (27). Use screw driver to hold inner flange (G) and tighten nut (J)
anti-clockwise, ensure the nut (J) is tightened enough.
To release the Cutting blade (Brush cutter) (27).
• Use screw driver to hold inner flange (G) and release nut (J), the Cutting blade (Brush
cutter) (27) can be removed.
m
Warning!
Please make sure the Cutting blade (Brush cutter) (27) has been assembled correctly
before use!
Note: The packaging material is made of recyclable materials. Dispose of packaging
materials in accordance with regulations.
6.
Fit the Carrying Belt (14). (Fig. 13-17)
m
Only use Grass trimmer (8) and Cutting blade (Brush cutter) (27) with the
Carrying Belt (14). Fit the tool to the belt at the beginning of each work session while
the engine is running and cutting tool is not started.
Be careful - Do not start the cutting tool!
• Wear the Carrying Belt (14) as shown in figure 14.
• Adjust the strap length so that the snap hook (L) is about a hand‘s breadth below the
right hip.
• For operation, hook the Motor drive unit (7) into the snap hook (L) of the Carrying
Belt (14).
• Balance the 5 in 1 Petrol Tool when the tool is switched off.
• When standing in a normal working posture, the cutting head should touch the
