28
AFTER SALES SUPPORT
1300 855 831
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Attachment and operation
Notes on tensioning the Saw chain (18):
The Saw chain (18) must be properly tensioned to ensure safe operation. When the Saw
chain (18) can be raised by around 2 mm in the Chain saw blade (19), you know that the
saw chain tension is ideal. During cutting, the temperature of the Saw chain (18) rises
and its length changes. It is important therefore to check the saw chain tension at least
every 10 minutes and to adjust it again as required. This applies in particular to new saw
chains. When you have finished working, slacken the Saw chain (18) again as it will short-
en when it cools down. This will help to prevent damage to the Saw chain (18).
9. Assembling the Edger Attachment
Pull the protective caps off of the ends of the shaft and keep them in a safe place for
later use.
B4
D
E
C
B
7
B1
B2
B
B3
9.1 Connecting drive tube to gearbox (B4)
1. Loosen the 2 clamping screws (B1+B2) on the gearbox (B4) of the Edger attachment
Do not remove!
2. Insert curved end of drive tube (B) in the gearbox (B4), turn the gearbox (B4) back
and forth as necessary.
3. Push the shaft in as far as it will go.
4. Align the gearbox on the shaft so that the screw (B2) is aligned with the hole (B3) in
the shaft.
5. Tighten the clamping screws (B1+B2) firmly.
6. Pull out the locking pin (E) and press the lower part of the shaft (B) downward un-
til the locking pin engages. The locking pin (E) is in the right position when it is fully
seated in the bore (C).
7. Lastly, tighten the knurled screw (D) securely.
Reverse the above sequence to remove the drive tube.
