AFTER SALES SUPPORT
25
1300 855 831
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS
Before starting the equipment/Attachment and operation
Never use oil for 4-cycle engine or use water cooled 2-cycle engine. It can cause spark
plug fouling exhaust part blocking or piston ring sticking.
Mixed petrols, which have been left unused for a period of one month or more, may clog
the carburettor or result in the engine foiling to operate property. Put remaining petrol
into an airtight container and keep it in the dark and cool room.
Petrol mixing table
Mixing procedure: 40 parts petrol to 1 part oil
Example:
1 L Petrol: 0.025 l 2-stroke oil
5 L Petrol: 0.125 l
2-stroke oil
Warning!
Take care of the emission of exhaust gases.
Always shut off engine before fuelling. Never add petrol to a machine with a run-
ning or hot engine. Take care of fire!
VIII. Attachment and operation
ASSEMBLY
When assembling this 5 in 1 Petrol Tool, please follow the instructions for assembly print-
ed.
1. Assemble the Front handle (1) on the 5 in 1 Petrol Tool. (Fig. 2-3)
• Install the Front handle (1) as shown on the image 3.
• Make sure that you align the pin with the hole. Tighten the screws only loosely before
you have the most comfortable working position set to the risers. The Front handle (1)
should be aligned as in figures 2+3 shown, then tighten the screws (A).
2. Mounting the shaft (B). (Fig. 4)
• Pull out the locking pin (E) and press the lower part of the shaft (B) downward un-
til the locking pin engages. The locking pin (E) is in the right position when it is fully
seated in the bore (C).
• Lastly, tighten the knurled screw (D) securely.
3.
Assemble the Protection shield (Brush Grass trimmer) (26). (Fig. 5-7)
m
Warning! Never use the 5 in 1 Petrol Tool without the guard assembled!
• Loosen the four screws at the protection shield (26) with a screwdriver.
• Place the protection shield (26) at the attachment for brush cutter (25).
• Tighten the four screws at the protection shield (26) again with a screwdriver.
