32
AFTER SALES SUPPORT
1300 855 831
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Working instructions
• Always wear safety glasses and hearing protection and a safety helmet.
Caution: Be especially careful, when using this working technique, because the further
away the cutting tool is from the ground, the higher is the risk that objects to be cut and
particles will be hurled sideways.
Mowing with Grass trimmer (Fig. 39)
• Use the grass trimmer for a clean cut when trimming uneven edges, or around fencing
posts or the base of trees.
• Carefully advance the trimming line to an obstacle, and use the tip of the line to cut
around the obstacle. When the trimming line comes into contact with stones, trees,
and walls, the line wears out or breaks off ahead of time.
• Swing the 5 in 1 Petrol Tool like a normal scythe horizontally from right to left and back
again. You define the cutting height depending on how high you are holding the 5 in
1 Petrol Tool.
•
m
Never replace the nylon line with a metal wire.
RISK OF INJURIES
Automatic thread trimming (Fig. 18)
The 5 in 1 Petrol Tool is delivered with a filled nylon line cassette.
This line will wear out during work. To feed new line, forcefully press the head of the line
cassette onto the ground while the engine is running at working speed.
The line is automatically fed due to centrifugal force.
The integrated blade (X) at the Protection shield (Brush Grass trimmer) (26) will
shorten the trimming line to the correct length.
Run the trim line approach cautiously to an obstacle and cut with the tip of the line
around the obstacle.
Mowing with Brush cutter
Use the Cutting blade (Brush cutter) (27) to comb through brushwood, rank growth,
young tree populations (trunk diameter of maximum 2 cm), and high grass.
• While using metal cutting tools, there is generally a risk of recoil, when the tool hits
a solid obstacle (stones, trees, branches, etc.). Thereby, the tool is hurled backwards
against the rotating direction.
• To cut rank growth and brushwood, you "immerse" the Cutting blade from the top.
Angle adjustment / Hedge trimmer (21)
By swivelling the Cutting unit (23), the Hedge trimmer (21) can be adjusted to the work-
ing conditions from 0° to 90°. (Fig. 42)
• Warning! Adjust the angle only when the motor has been turned off.
• Push both levers down and put the cutter head in the required position. (Fig. 41)
• Release both levers until they click into place in the notch.
• Before use, check that the adjustment levers have clicked into place properly. (Fig. 42)
Oil the blades and the angle adjustment each time before starting work, with environ-
