AFTER SALES SUPPORT
39
1300 855 831
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS
Maintenance
6. Then place the line guard cap (A6) on the new line spool (A7). Turn it so that the plates
of the line guard cap (A6) are pushed with the springs in the line spool housing (A8).
7. Now, press the line guard cap (A6) together with the line spool (A7), until it engages in
the line spool housing (A8).
8. The integrated blade (X) in the Protection shield (Brush Grass trimmer) (26)
shortens the trimming line to the correct length, when the engine starts again.
Grinding the integrated blade (X) in the Protection shield
(Brush Grass trimmer) (26)
The integrated blade (X) in the Protection shield (Brush Grass trimmer) (26) can
become blunt over time.
• When you notice this, undo the screws holding the cutting blade (X) on the Protection
shield.
• Clamp the cutting blade (X) in a vise.
• Sharpen the cutting blade (X) with a flat file and make sure that the angle of the cut-
ting edge is not altered in the process. File in one direction only.
• Important! Reassemble the cutting blade (X).
Replacing and resharpening the cutting blade (X) at the end of the mowing season.
Always resharpen the cutting blade (X) or, if required, replace the cutting blade (X) with
a new one.
Grinding Cutting blade (Brush cutter) (27)
If the Cutting blade (Brush cutter) (27) is only slightly dull, they can be sharpened.
• Clamp the Cutting blade (Brush cutter) (27) in a vise.
• Sharpen the Cutting blade (Brush cutter) (27) with a flat file and make sure that the
angle of the cutting edge is not altered in the process. (~25°) File in one direction only.
• Replace the Cutting blade (Brush cutter) (27) after having re-sharpened five times.
Replace the blade with heavy wear or broken blade.
Unbalanced blades will cause the brush cutter to vibrate violently-risk of accident!
Lubricate angle transmission / Pole saw
Lubricate with lithium-based grease. Use screw (R) and put in the grease, turning the
shaft manually until grease emerges.
Change and clean the spark plug (A10) (Fig. 30-31)
Check the spark plug air gap at least once a year or when the engine starts poorly. The
correct gap between ignition flag and ignition contact is 0.25"/0.63 mm.
• Wait until the engine has cooled down completely.
• Pull the spark boot plug (A9) out off the spark plug (A10), and use the supplied spark
plug wrench (10) to remove the spark plug by turning.
• When the electrode is severely worn out or reveals a strong incrustation, the spark
