3.5.3 To install the boundary wire
CAUTION:
Do not put remaining wire in
a coil. The coil causes interference with the
product.
1.
Put the boundary wire around all of the work
area. Start and complete the installation behind the
charging station.
2.
Open the connector and put the boundary wire in
the connector.
3.
Close the connector with a pair of pliers.
4.
Cut the boundary wire 1-2 cm / 0.4-0.8 in. above
each connector.
5.
Push the right connector onto the metal pin on the
charging station with the mark "R".
6.
Push the left connector onto the metal pin on the
charging station with the mark "L".
3.5.4 To install the guide wire
CAUTION:
Twinned cables, or a
screw terminal block that is insulated with
insulation tape are not satisfactory splices.
Soil moisture will cause the wire to oxidize
and after a time result in a broken circuit.
1.
Open the connector and put the wire in the
connector.
2.
Close the connector with a pair of pliers.
3.
Cut the guide wire 1-2 cm / 0.4-0.8 in. above each
connector.
4.
Push the guide wire through the slot in the
charging station plate.
5.
Push the connector onto the metal pin on the
charging station with the mark "G".
6.
Disconnect the charging station from the power
outlet.
7.
Put the end of the guide wire at the eyelet on the
boundary wire.
8.
Cut the boundary wire with a pair of wire cutters.
9.
Connect the guide wire to the boundary wire with a
coupler.
a)
Put the 2 ends of the boundary wire and the
end of the guide wire into the coupler.
Note:
Make sure that you can see the ends
of the wires through the transparent area of
the coupler.
b)
Push down the cover on the coupler with
adjustable pliers to attach the wires in the
coupler.
10. Attach the guide wire to the ground with stakes or
bury the guide wire in the ground. Refer to
the wire into position with stakes on page 17
or
To bury the boundary wire or the guide wire on
page 18
.
11. Connect the charging station to the power outlet.
3.6 To put the wire into position with
stakes
CAUTION:
Make sure that the stakes
hold the boundary wire and the guide wire
against the ground.
1585 - 007 - 26.10.2022
Installation - 17
