5.3 Replacement of the blades
WARNING:
GARDENA can only
guarantee safety if you use GARDENA
original blades with the embossed crowned
H-mark logotype.
WARNING:
You must replace the
screws when you replace the blades. The
used screws can wear quickly and make the
blade come loose, this can cause serious
injury.
Replace worn or damaged blades for a safe operation.
Replace the blades regularly for a satisfactory cut result
and a low energy use. All 3 blades and screws must
be replaced at the same time to get a balanced cutting
system.
5.3.1 To replace the blades
1.
Push the STOP button.
2.
Push the ON/OFF button for 3 seconds to set the
product to OFF. Make sure that the LED indicator
on the keypad goes off.
3.
Put the product with the blade disc up on a soft
and clean surface.
4.
Remove the 3 screws.
5.
Remove each blade and screw.
6.
Attach new blades and screws.
7.
Make sure that the blades can pivot freely.
5.4 Firmware update
If service is done by GARDENA service, available
firmware updates are downloaded to the product by the
service technician. Owners of GARDENA products can
update the firmware if this is initiated by GARDENA.
Registered users are in that case notified.
5.4.1 To update the firmware
1.
Remove the rubber plug.
2.
Connect a USB printer cable (USB A and USB B
contacts) in the product and your computer. The
USB printer cable is available as an accessory.
3.
Go to www.gardena.com, search for and download
the firmware update tool and follow the
instructions.
4.
Remove the USB printer cable.
5.
Attach the rubber plug and make sure that it seals
fully.
CAUTION:
Make sure that the rubber
plug seals fully to prevent moisture.
1585 - 007 - 26.10.2022
Maintenance - 27
