4.3.5.1 To override the schedule
This can be set in the dashboard in the app or with the
keypad on the product:
1.
Push the STOP button.
2.
Push the Start button for 1 second.
3.
Push the OK button.
4.3.6 Spot cutting
Use the
Spot cutting
function to quickly cut an area
where the grass has been cut less than in other parts
of the yard. You must manually move the product to the
selected area. This operating mode can only be set in
the app.
Spot cutting means that the product operates in a spiral
pattern in order to cut the grass in the area where it was
started. When this is done, the product automatically
switches back to
Main area
or
Secondary area
.
4.4 To stop the product
1.
Push the STOP button on top of the product.
Note:
When the STOP button is pushed the product
will be idle. The product stops and the cutting motor
stops.
4.5 To set the product to OFF
1.
Push the STOP button.
2.
Push the ON/OFF button for 3 seconds to set the
product to OFF. Make sure that the LED indicator
goes out.
4.6 To charge the battery
WARNING:
Only charge the product
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
When the product is new or has been stored for a
long period, the battery can be empty and needs to
be charged before starting. In the
Main area
mode, the
product automatically alternates between mowing and
charging.
1.
Push the ON/OFF button to start the product.
2.
Put the product in as far as possible in the
charging station. Make sure that the product and
the charging station is connected. Refer to contact
and charging strips in
Product overview on page 7
4.7 Cutting height adjustment
CAUTION:
The first weeks after a new
installation, set the cutting height to 3 to
prevent damage to the loop wire. You can
then lower the cutting height each week.
You can select between 3 different cutting height steps.
The blade disc has marks for each step. Step 1 is the
lowest height, step 2 is the middle height, and step 3 is
the highest height. The factory setting is set to 3.
24 - Operation
1585 - 007 - 26.10.2022
