6.3 Information and warning messages
The information messages in the table below are shown in the app. Speak to your GARDENA service if the same
message shows frequently.
Message
Cause
Action
Settings restored
A
Reset all user settings
has been done.
Usual operation of the product.
Zone generator problem
The battery of the ZoneProtect accessory
is low. The ZoneProtect does not operate
when the battery is empty. The product
can cut in the stay-out zone if you start
the product before you charge the Zone-
Protect.
Park the product and charge the ZonePro-
tect accessory before you start the prod-
uct.
The temperature in the ZoneProtect ac-
cessory is a higher than the maximum limit
and is set to off.
Put the product in an area with protection
from the sun. Let the temperature of the
ZoneProtect accessory decrease before
you start the product.
Guide not found
The guide wire is not connected to the
charging station.
Connect the guide wire to the charging
station. Refer to
on page 17
.
Damage in the guide wire.
Replace the damaged section with new
guide wire.
The guide wire is not connected to the
boundary loop.
Connect the guide wire correctly to the
guide wire on page 17
.
Loop signal created
New loop signal changed.
Usual operation of the product.
Needs manual charging
The product is set to the
Secondary area
operating mode.
Put the product in the charging station.
Next start hh:mm
The schedule setting prevents the product
from operating.
Change the schedule settings. Refer to
Make an estimate of the necessary operat-
.
The product has operated the maximum
cutting time for the day.
Usual operation of the product.
Today's mowing comple-
ted
The product has operated the maximum
cutting time for the day.
Usual operation of the product. Refer to
.
Connection NOT changed
The loop signal was not changed because
of an error.
Make a
New loop signal
a number of
times. Refer to
21
. If the problem stays speak to your
GARDENA service.
34 - Troubleshooting
1585 - 007 - 26.10.2022