Gardena SILENO minimo, Руководство оператора

Страница: 16 / 44

certain distance (C). The settings can be changed
in
Lawn Coverage and CorridorCut on page 19
.
• If the work area includes a secondary area
(D), refer to Secondary area on page 23 . Put
the product in the secondary area and select
Secondary area mode .
B
D
C
A
3.5 Installation of the product
3.5.1 Installation tools
• Hammer/plastic mallet: To simplify putting the
stakes into the ground.
• Edge cutter/straight spade: To bury the boundary
wire.
• Combination pliers: For cutting the boundary wire
and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
3.5.2 To install the charging station
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
Make sure that the plugs of
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When connecting the power supply, only use a power
outlet that is connected to an residual-current (RCD)
device.
1.
Read and understand the instructions about the
charging station. Refer to To examine where to put
the charging station on page 11
.
2. Put the charging station in the selected area.
Note:
Do not attach the charging station to the
ground with the screws until the guide wire is
installed. Refer to
To install the guide wire on page
17 .
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
cm / 12 in.
min 30 cm / 12”
5. Connect the power supply cable to a 100-240V
power outlet.
Note:
When the charging station is connected,
it is possible to charge the product. Place the
product in the charging station while the boundary
and guide wires are being laid. Switch on the
product. Do not continue with any product settings
before the installation is complete.
6. Put the low-voltage cable in the ground with stakes
or bury the cable. Refer to
To put the wire into
position with stakes on page 17 or To bury the
boundary wire or the guide wire on page 18
.
7. Connect the wires to the charging station after
the installation of boundary wire and guide wire is
complete. Refer to To install the boundary wire on
page 17
and
To install the guide wire on page
17 .
8. Attach the charging station to the ground with the
supplied screws after the guide wire is installed.
Refer to
To prepare for installation on page 11
.
16 - Installation 1585 - 007 - 26.10.2022