G&D DP1.2-VisionXG-Fiber Series, Инструкция по установке и эксплуатации

Страница: 95 / 156

Installation
G&D DP1.2-VisionXG-Fiber · 14
English
Establishing a connection to the computer module
Transmission|Tx: Insert the LC plug of the fibre optic cable, which is connected to the
Transmission|Rx interface of the computer module.
Transmission|Rx: Insert the LC plug of the fibre optic cable, which is connected to the
Transmission|Tx interface of the computer module.
Additional interfaces of expanded variants
Line In: Connect a microphone to this interface if desired.
Line Out: Connect the console speakers or another audio output device to this interface.
RS232: Connect the serial end device to this interface.
USB 2.0 Devices:
Connect any USB device to these four interfaces.
IMPORTANT: The device uses components with laser technology which comply
with laser class 1.
Never stare into the invisible laser beam when wearing optical instruments!
NOTE:
Remove the protection caps from the Transmission interface and the cable
plugs.
NOTE: Connect at least one of the user module’s Transmission sockets (two fibres)
to the computer module.
If the bandwidth of the cable connection(s) is
insufficient for the transmission of the
signals, image errors occur. In this case, connect other transmission sockets to the
computer module.
IMPORTANT: The interfaces listed in this paragraph are only provided at certain
variants.
DP Out Transmission
A B
Network A
Network B
PS/2
Generic
Keyb./Mouse USB 2.0 Devices
Host
Link
RS232 In Out
Line
USB 2.0 Devices
Host
Link
PS/2
Generic
Keyb./Mouse DP Out Ready Ident.
System Fail
Network A
Network B