G&D DP1.2-VisionXG-Fiber Series, Инструкция по установке и эксплуатации

Страница: 93 / 156

Installation
G&D DP1.2-VisionXG-Fiber · 12
English
Establishing the power supply
Main Power: Insert one of the supplied PowerCable-2 Standard IEC cables here.
Red. Power: Insert one of the supplied PowerCable-2 Standard IEC cables here. This es-
tablishes a second, redundant power supply for the user module.
Installing the user module
The remote console is connected to the DP1.2-VisionXG-Fiber-CON user module. The
computer connected to the computer module can be operated over this console.
Establishing a connection to up to two local networks
Network A: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Network B: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
ADVICE:
Connect the cables to the computer module preferably from left to right.
By doing so, you will avoid already connected cables blocking your view of the
interfaces.
NOTE:
If desired, connect the network interface to up to two local networks. Now
you can not only access the Config Panel web application from those networks but
also send syslog messages to those networks.
Main Power Red. Power
Power
Red.
Main
USB 2.0 CPU
RS232
In Out
Line
PS/2 CPU USB CPU PS/2 USB K/M Network A
Network B
Ready Ident.
System Fail
PS/2 CPU USB CPU
Network A
Network B
PS/2
Generic
Keyb./Mouse
DP Out
USB 2.0 Devices
Host
Link
Transmission
A B