GALILEOSKY GLONASS/GPS Satellite v4.0 (0223) User’s manual
GalileoSky Ltd.
Page 39
9.4
Command mode tab
This tab is intended to message a single command or a set of commands to the Terminal.
The command mode has the following buttons:
1)
Run commands;
2)
Run single command;
3)
Open from file;
4)
Save to file.
The commands will be identified whether you use capital or lower-case letters or both in turn.
Attention!
There are no spaces in command name!
Spaces between parameters are not allowed!
Commands and parameters are separated by space.
Commands are separated by Enter.
Single command example
An example of a command with a parameter:
In the Commands window
enter APN internet.beeline.ru,beeline,beeline as shown in the figure above and
press
Run single command
button. The command and a response will be displayed in the Responses
window.
Command
:
APN internet.beeline.ru,beeline,beeline
Response
:
GPRS:APN=INTERNET.BEELINE.RU, user=BEELINE, pass=BEELINE;
To access the parameters in the Terminal memory you should use a command without parameters!
An example of a command without a parameter:
APN command
Request:
APN
Response:
GPRS:APN=INTERNET.BEELINE.RU, user=BEELINE, pass=BEELINE;
