GALILEOSKY GLONASS/GPS Satellite v4.0 (0223) User’s manual
GalileoSky Ltd.
Page 25
4)
Visually indicate the shift using a mouse. The number transmitted to the server will be displayed in
the Value Column.
J1939_USER_11bit
mode is set similarly.
8.1.4
J1979_SCANER mode
This mode is used to define data transfer rate and Identifier length according to J1979 protocol. If the
parameters
of transfer are known, it is recommended to use the J1979_29bit and J1979_11bit modes,
having specified necessary rate of the bus.
The rate of 250000 bits per second and 500000 bits per second and 11 and 29 bit identifiers are supported.
To enable this mode:
1)
connect the Terminal to the vehicle’s CAN interface;
2)
press “Test OBD ΙΙ”. Received data are displayed in the right panel.
3)
If scanning finished successfully, data transfer rate and Identifier length will be set automatically.
Attention
! Scanning according to J1979 protocol can cause failures in on-board equipment operation.
GalileoSky Ltd bears no responsibility for any failures after CAN-bus scanning.
8.1.5
J1979_29bit mode
This mode allows extracting and decoding the messages with 29 bit identifiers, transferred according to
J1979 protocol automatically:
tank fuel level: measured in percent. 0%-empty, 100%- full;
coolant temperature;
engine speed ;
errors codes.
Attention!
Many car manufacturers support J1979 partially or do not support it at all.
To enable this mode:
1)
connect the Terminal to the vehicle’s CAN interface;
2)
give the CanRegime command (section
CAN settings
) or select OBD ΙΙ 29bit filter type in the
Configurator on Settings/CAN tab;
3)
make sure the device receives bus data and sends them to Device tab in the Configurator;
4)
set the right data transmission to the server using the MainPack command (section
Server
exchange protocol settings
) or in the Configurator on Settings/Protocol tab.
J1979_ 11bit
mode is set in a similar way.
Attention!
If your vehicle doesn’t support J1939 protocol,
J1979_29bit
and
J1979_11bit
modes operation
can cause failures of board equipment operation. GalileoSky Ltd bears no responsibility for failures after
activation of these modes.
