FUTABA FMT-03, Инструкция по эксплуатации

Страница: 57 / 68

57 <Functions of Linkage Menu>
Trim setting
Use the edit dial to move the cursor to the
"TRIM" item of the channel you want to
change and push the RTN button.
*The trim setup screen is displayed.
The following items can be set at the trim
setup screen:
*The setting can be changed for each condition.
After the set mode is changed from group mode [G] to
single mode [S] at the control selection screen, only that
condition setting is changed by control change; setting of
other conditions remains the same.
Trim selection
Use the edit dial to move the cursor to the
trim, lever, etc. you want to set and push the
RTN button.
*The setting can be changed.
Trim rate setting
Use the edit dial to move the cursor to the
[RATE] item and push the RTN button to
switch to the data input mode.
Set the trim rate by turning the edit dial.
Initial value: +30%
Adjustment range : 0~150%
(When the RTN button is pushed for 1 second, the trim rate is
reset to the initial value.)
Push the RTN button to end adjustment and
return to the cursor move mode.
Trim mode selection
Use the edit dial to move the cursor to the
[TRIM MODE] item and select the trim mode
by turning the edit dial.
[NORM]: Normal mode. Normal trim (parallel
shift trim) operation.
[ATL]: ATL operation mode. Maximum
change near center by operation normally
used with throttle trim. Reverse is also
possible.
[NORM]/[REV] selection is possible at the "ATL
REV" item.
[CENTER]: Maximum change near center by
center trim operation.
WARNING
As a safety precaution to prevent the motor
from starting unexpectedly, please switch
off the motor accordingly. We also suggest
removing the propeller from the motor as an
additional precaution.