64
<Functions of Linkage Menu>
S1
<Edit dial>
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
Home/Exit button.
TIMER
Timer setting
The Timer function may be set for any desired
time, i.e. engine run time, specified times for
competitions, etc. Two independent timers are
provided for your use. The timers are stored
independently with each model, meaning that
when you switch between model setups, the timer
associated with the new model is brought up
automatically.
The timers may be set to start and stop from
the motion of any switch or stick. You may set the
ON and OFF directions freely. Each timer has a
capacity of up to 59 minutes 59 seconds.
Timer setting
*Perform the following settings after using the edit dial to
move the cursor to the item you want to set.
1. Up timer/down timer setting
Move the cursor to the [MODE] item and
push the RTN button to switch to the data
input mode.
Select the mode by moving the edit dial to
the left or right and push the RTN button.
[UP]: Up timer
[DOWN]: Down timer
2. Timer time setting
Move the cursor to the [10]:[100] item and
push the RTN button to switch to the data
input mode.
Set the time by turning the edit dial to the left
or right.
[00]:[00]:[min]:[sec]
Push the RTN button to end adjustment and
Each timer may be set for count-down or count
up operation with a target time.
If a target time is set and the timer reaches the set
time, a buzzer sound for each count is generated.
Countdown timers sound one short beep during
the last twenty seconds and two short beeps during
the last ten seconds before reaching the target, then
a long tone at the target time, and continue counting
with displaying a minus (-) sign. Count-up timers
also beep the last twenty and ten seconds, beep the
target time, and keep counting upwards until shut
down.
return to the cursor move mode.
3. Switch setting
Move the cursor to the item of the switch
you want to set, call the switch setup screen
by pushing the RTN button, and select the
switch and ON direction.
[For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.]
[RESET SW]: Reset switch
[START SW]: Start switch
[STOP SW]: Stop switch
Timer operation
● Timer 1 and Timer 2 are started/stopped by
pre-selected start/stop switch.
● To reset a timer, operate the pre-selected
reset switch, or move the cursor to the [RESET]
display on the timer screen and push the RTN
button.
● Select [TIMER] at the linkage menu and call the setup
screen shown below by pushing the RTN button.
● The timer value is held even if the
power is turned off or the model is
switched.
Memory
→
ON
●Calling setup
screen
Scrolling
● Moving cursor
● Selecting mode
Содержание FMT-03
Страница 1: ...1M23Z04404 For model...
