FUTABA FMT-03, Инструкция по эксплуатации

Страница: 53 / 68

53 <Functions of Linkage Menu>
S1
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
Home/Exit button.
<Edit dial>
MODEL TYPE
This function selects the model type from among multicopter,
airplane, helicopter, and glider.
(The display screen is an example. The screen
depends on the model type.)
Seven types of main wings and three types
of tail wings are available for airplanes. Eight
swash types are available for helicopters. Seven
types of main wings and three types of tail wings
are available for gliders. Functions and mixing
functions necessary for each model type are set in
advance at the factory.
Note: The Model Type function automatically selects
the appropriate output channels, control functions,
and mixing functions for the chosen model type.
When the Model Type Selection command is
accessed, all of the data in the active memory is
cleared (except the following swash type.) Be sure
that you don’t mind losing this data, or back it up to
another memory using the copying functions.
When you change the helicopter swash type
within the following each group, you can leave
the setting data other than the SWASH function. In
this case, confirmation screen appears. However,
it is initialized when you change the swash type
exceeding the group.
Model type selection
1. Use the edit dial to move the cursor to the
item you want to change and then call the
selection screen by pushing the RTN button.
"TYPE": Model type
"WING" (airplane/glider): Wing type
"TAIL" (airplane/glider): Tail type
"SWASH" (helicopter): Swash type
2. Use the edit dial to move the cursor to the
type you want to change and select the
type by pushing the RTN button.
*When the model type was changed, the wing type, tail
type, or swash type selection screens sequentially appear
according to the model. Finally, the blinking confirmation
message "MODEL TYPE CONFIRMATION" appears.
3. Push the RTN button to execute the change.
(Operate the edit dial or S1 button to stop
the change.)
*The model types which are displayed (which can be
selected) depend on the type of receiver used. See Servo
Connection by Model Type.
● Select [MODEL TYPE] at the linkage menu and call the
setup screen shown below by pushing the RTN button.
Swash type group A:
H-1, H-2, H-3, HR3, HN3, and HE3
Swash type group B:
H-4, H-4X
●Calling setup
screen
Scrolling
● Moving cursor
● Selecting mode
FMT-03 is equipped with a stick of multi-copter
exclusive use. Therefore it's unsuitable for use
of an airplane, a glider and a helicopter.