54
<Functions of Linkage Menu>
S1
<Edit dial>
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
Home/Exit button.
System Type selection
The FMT-03 is for 2.4GHz only. The system
can be changed from among 2 choices: FASSTest
18CH and FASSTest 12CH which can be chosen by
FMR-03 set.
*If you change the System Type, other model data is not
reset.
*After any change, remember to test the model and should
fully check servo direction and a motion.
*Analog servos cannot be used with the FMR-03 in the
FASSTest 12CH mode.
SYSTEM TYPE
System mode setting, Receiver link
Receiver linking
The receiver will only be controlled (without
being affected by other transmitters) by the
transmitter it is linked to. When using a receiver
other than one purchased as a set, linking is
necessary.
Moreover, a re-link is required when a new
model is added by model selection, and the time of
system type change.
Dual receiver function (only FASSTest 18CH
mode)
Dual receivers can be linked with the FMT-03.
Two receivers are recognized individually by ID
numbers. Two sets of receivers can be used as a set
in the model. Separate fail-safe voltage can be set
to each receiver.
However, telemetry cannot be used for the 2nd
receiver.
Battery fail-safe voltage setup (only FASSTest
mode)
The voltage which battery fail-safe activates,
can be set when you link. (3.5-8.4V) The receiver
memorizes the setting as it was at link.
Suggested setting voltages are as follows.
• 4 cells NiCd or NiMH (Normal: 4.8v) = 3.8 v
• 2 cells LiFe (Normal: 6.6 v) = 5.2 ~ 5.4 v
• 2 cells LiPo (Normal: 7.4 v) = 6.6 ~ 6.8 v
It is a rough reference value.
Since it changes with servos carried in the
condition and the model of a battery, please set to
your own model in a battery consumption current.
● Select [SYSTEM] in the Linkage menu and access the
setup screen shown below by pushing the RTN button.
P.33
Linking method
Cases when linking is necessary:
・
When using a receiver other than the initial setting.
・
When the communication system was changed.
(FASSTest 18CH
↔
FASSTest 12CH etc.
)
・
When a new model was created by model
selection.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
Содержание FMT-03
Страница 1: ...1M23Z04404 For model...
