FUTABA FMT-03, Инструкция по эксплуатации

Страница: 23 / 68

23 <Before Use>
● S.BUS2
Connector
●
Be careful about the direction of connector.
●
LED Indication
LED Monitor
Green Red Status
Off Solid
No signal reception
Solid Off Receiving signals
Alternate blink Unrecoverable error (EEPROM, etc.)
Direction of connector
Receiver FMR-03
(Typical installation)
Antenna
Link/Mode
Switch
Power supply
S.BUS/S.BUS2 Signal
LED
FMR-03
Attachment
Connector
LF3WBP-12S
3.7V 〜 7.4V
(It is not used for a link.)
S.BUS/S.BUS2 equipment
S.BUS Modes S.BUS2
⇔
S.BUS
1
Press and hold down the Link/Mode
b u t t o n o n t h e F M R -03 r e c e i v e r .
[Transmitter is always OFF]
2
Turn the receiver on while holding down
the Link/Mode button. After power up,
the button can be released.
3
The LED should now be blinking red with
green.
4
Each press of the Mode/Link button
advances the receiver to the next mode.
[Refer to S.BUS Mode table shown next.]
5
When you reach the mode that you wish
to operate in, press and hold the Mode/
Link button for more than 2 seconds.
6
When LED blinks in green with red, it is the
completion of a mode change.
7
Please cycle the receiver power off and
back on again after changing the S.BUS
Mode.
*5 seconds after the receiver ON, LED shows
S.BUS Mode.
The FMR-03 is capable of changing its S.BUS modes as described in the table next. Please choose the mode
which suited the use in the following procedure from the S.BUS or S.BUS2 modes.
S.BUS mode LED Signal
A Red 1 time
B Red 2 times
C Red 3 times
D Red 4 times
E Green 1 time
F Green 2 times
G Green 3 times
H Green 4 times
I Red Green 1 time
J Red Green 2 times
K Red Green 3 times
Default
FMR-03 S.BUS Mode table