Furuno DS-8500, Руководство по установке

Страница: 48 / 94

3. ADJUSTMENTS
3-4
3.1.1 [TRANSDUCER] menu
On the [EQUIPMENT] sub menu, select
[TRANSDUCER] to open the [TRANS-
DUCER] menu.
[TYPE]
Shows the type for the transducer which is set the transducer initial setting. See
page 3-1 for the transducer initial setting.
To change the type, execute [TYPE CLEAR] then set the transducer settings again.
[TYPE CLEAR]
Select [YES] on the confirmation message to reset the default settings for the setup of
the transducer.
[OFFSET]
If the transducer is not installed parallel to the bow-stern keel line, correct the error in
the equipment angle. Set the calibration angle for the transducer position (default: 0°).
The setting range is -135° to -180°, -45° to 45° and 135° to 180. Set the clockwise di-
rection as + with viewing the transducer from above.
[CABLE LENGTH]
Shows the cable length of the transducer which is set at initial setting. See page 3-1
for the transducer initial setting. Make sure that the length is correct for calibration by
the temperature sensor.
To change the cable length, execute [TYPE CLEAR] then set the transducer settings
again. see page 3-4 for [TYPE CLEAR].
[XDCR POSITION]
Open the [XDCR POSITION] window to set the position for each transducer. The set-
ting range for the number of the transducer is [01] to [99] (default: [01]).
For each transducer, set the X-axis distance (between bow and stern) and Y-axis dis-
tance (between left (-) and right (+) from the center of ship).