Furuno DS-8500, Руководство по установке

Страница: 40 / 94

2. WIRING
2-10
2.5 Transceiver Unit
2.5.1 How to fabricate the cables
Attach the SC lock and the packing (pre-attached to the cable entry on the transceiver)
to the cable before fabricating the cable. Please pay attention to the orientation of the
SC lock and packing.
Signal cable
The cables listed in the table below can be used for the transceiver unit.
Depending on the used cable, the type of the SC lock and the fixing location on the
cable are various, referring to the table below. The appropriate SC lock must be at-
tached at the appropriate location on the cable.
When using the optional junction box, fabricate the cable as in the previous figures.
Type of cable
Replacement to
OP65-4
Fixing location
on the cable
Remarks
TTYCYSLA-4
—
On the outer
sheath
TTYCSLA-4 Required On the armor No outer sheath
• TTYCY-4S
• TTYC-4S
—
On the inner
sheath
Cable for DS-80
Other cable
φ
14.5 to 16.5?
Required
Attach the crimp-on lug to the core.
Shield Shield
Power Power
Wrap the shield line on the inner sheath. Wrap the shield line on the inner sheath.
Signal Signal
Outer sheath* Outer sheath*
SC lock
(Fixing location is
different depending
on the cable type)
SC lock
(Fixing location is
different depending
on the cable type)
Gasket Gasket
Armor Armor
Wrap the supplied conductive tape CCTE-20.
Wrap the both sides of the conductive
tape with vinyl tape.
Clamp on the conductive tape. Clamp on the conductive tape.
40 40 66
190 190
Inner sheath Inner sheath
60 60
Sheath Sheath Armor Armor
Gasket Gasket
*: If the outer jacket is an armor, the sheath fabrication is as follows.