Fujitsu PRIMERGY RX200 S8, Руководство по модернизации и обслуживанию

Страница: 34 / 336

34 Upgrade and Maintenance Manual
RX200 S8
Important information
●
Only set screen resolutions and refresh rates that are specified in the
operating manual for the monitor. Otherwise, you may damage your monitor.
If you are in any doubt, contact your sales outlet or customer service center.
●
Before installing/removing internal options to/from the server, turn off the
server, all peripheral devices, and any other connected devices. Also unplug
all power cords from the outlet. Failure to do so can cause electric shock.
●
Do not damage or modify internal cables or devices. Doing so may cause a
device failure, fire, or electric shock and will void the warranty and exempt
the manufacturer from all liability.
●
Devices inside the server remain hot after shutdown. Wait for a while after
shutdown before installing or removing internal options.
●
The circuit boards and soldered parts of internal options are exposed and
can be damaged by static electricity. To ensure reliable protection, if you are
wearing an earthing band on your wrist when working with this type of
module, connect it to an unpainted, non-conducting metal part of the system.
●
Do not touch the circuitry on boards or soldered parts. Hold the metallic
areas or the edges of the circuit boards.
●
Install the screw removed during installation/detaching internal options in
former device/position. To use a screw of the different kind can cause a
breakdown of equipment.
●
The installation indicated on this document is sometimes changed to the
kind of possible options without notice.
Batteries
●
Incorrect replacement of batteries may lead to a risk of explosion. The
batteries may only be replaced with identical batteries or with a type
recommended by the manufacturer.
●
Do not throw batteries into the trash can.
●
Batteries must be disposed of in accordance with local regulations
concerning special waste.
●
Make sure that you insert the battery the right way round.
●
The battery used in this device may present a fire or chemical burn hazard
if mistreated. Do not disassemble, heat about 100 °C (212F), or incinerate
the battery.