50
Rev. 8.0
A26361-K863-Z102-8-7619
Management Blade Configuration
Preparation for Use and Operation
I
The management blade LAN controller only runs at 10 Mbit/sec.
Duplex mode must be defined manually via the
Agent NIC Duplex Mode
(see figure 21 below).
Figure 21: Agent NIC Duplex Mode menu
Ê
Enter
2
if the preset duplex mode value needs to be altered or
0
.
I
The transfer rate of 10 Mbit/sec and the duplex mode of the
management blade must comply with the client LAN controller!
Automatic synchronization is not supported by the management
blade LAN controller.
Ê
Enter 0 in this menu and in the preceding menus to leave the management
blade console menu.
Ê
Close the HyperTerminal session.
Ê
Unplug the power cable from the blade server and plug it in again to reboot
the management blade.
I
This makes sure that the management blade keeps the master role
after reboot. A reboot without disconnecting the power cable would
cause a change of roles.
The management blade can now be accessed remotely via LAN. For infor-
mation on further configuration please refer to the manual “PRIMERGY
BX Blade Server Systems - RemoteView Management Blade (User Interface
Description)”. The configuration of the LAN switch blades is described in the
manual “PRIMERGY BX Blade Server Systems - LAN Switch Blade (User
Interface Description)”.
Содержание PRIMERGY BX300
