Fujitsu PRIMERGY BX300, Руководство по эксплуатации

Страница: 36 / 163

26 Rev. 8.0
A26361-K863-Z102-8-7619
Installing the System Into the Rack Installing the Hardware
3rd-Party Rack
Certain boundary conditions are to be fulfilled:
– Installation dimensions (see the dimensions shown in figure 3 on page 27).
– Please ensure the functionality of the security mechanism (e. g. stopper or
retention system) on the server.
– The form of the rack support uprights must ensure the frontal screwing on of
the rails.
– Frontally bolted rails.
The rails are provided with a linear alignment possibility to ensure also an
adjustment to different rack depths.
– No support of the cable management (delivered with the mounting kit).
– Climatic conditions.
For the ventilation of the installed server a large extent unhindered air intake
in the rack front and air discharge in the rear cover of the rack are necessary.
In principle the ventilation concept plans that the necessary cooling is
reached by the horizontal self-ventilation of the installed devices (air flow
from the front to the rear).
– Power supply.
For the installation in 3rd-Party Racks it is to be made certain that appro-
priate socket strips are present.
1 rack front side
2 rack rear side
A rack depth (comparison PRIMECENTER Rack 940/1000 mm)
B rack width (comparison PRIMECENTER Rack 700 mm)
C clearance of the 19-inch installation level
C1 front 19-inch installation level
C2 rear 19-inch installation level
D area for cable routing (cable area depth) and ventilation
E area for front panel and ventilation
F right and left area for support systems
P PRIMERGY installation depth
a1 front left support upright
a2 front right support upright
b1 rear left support upright
b2 rear right support upright