Fujitsu Oracle M10-1, Руководство по обслуживанию

Страница: 123 / 254

*1 If the logical domain operates in the factory-default state, this step is not necessary.
*2 For operation of the logical domain in a state other than factory-default, this step must be performed if XCP
version used is XCP 2271 or later and Oracle VM Server for SPARC 3.1 or later is used.
Table 7-11 System-stopped/cold addition work procedure (for memory)
Item Work procedure Reference
1 Opening the rack door
2 Switching the mode switch on the
operation panel to Service mode
" 5.2 Switching the Mode Switch to Service Mode "
3 Checking the operating condition
of the system and the I/O device
usage status
" 5.3 Checking the Operating Condition and Resource Usage Status "
4 Enabling recovery mode (*1) (*2) " 5.6.2 Setting recovery mode "
5 Saving logical domain configuration
information (*1)
" 5.6.3 Saving the logical domain configuration information and
OpenBoot PROM environment variables "
6 Stopping the system " 5.5 Stopping the Entire System "
7 Removing the power cords " 5.8.1 Removing the power cords "
8 Installing memory " 16.5.1 Accessing the motherboard unit "
" 16.6.2 Installing memory "
" 16.6.3 Restoring the chassis "
9 Installing the power cords " 6.1.6 Installing the power cords "
10 Performing a diagnosis test " 6.4 Diagnosing a Replacement FRU "
11 Confirming that there is no
problem with the installed memory
" 6.7 Checking the FRU Status after Maintenance "
12 Returning the mode switch on the
operation panel to Locked mode
" 6.8 Returning the Mode Switch to Locked Mode "
13 Starting the system " 6.9 Starting the System "
14 Confirming that the logical domain
configuration is the same as that
before memory was installed(*1)
" 6.5.2 Confirming that the logical domain configuration is the same
as that before memory was installed "
15 Restoring logical domain
configuration information
(Perform this step only if the logical
domain configuration differs from
that before memory was installed.)
(*1)
" 6.5.3 Restoring the logical domain configuration information and
OpenBoot PROM environment variables "
16 Closing the rack door
*1 If the logical domain operates in the factory-default state, this step is not necessary.
*2 For operation of the logical domain in a state other than factory-default, this step must be performed if XCP version used is XCP 2271
or later and Oracle VM Server for SPARC 3.1 or later is used.
Chapter 7 Maintenance Flow 109