Fujitsu Oracle M10-1, Руководство по обслуживанию

Страница: 32 / 254

Table 2-4 Functions of the power switch (continued)
Icon Operation Description
If the system stop process
is in progress in Service
mode:
Continues the system stop process.
If the system is stopped in
Service mode:
Operation is ignored.
Even a long press does not start the system.
If the system is stopped in
Locked mode:
Starts the system.
If a wait time for the air conditioning facilities or
a warm-up time is set on the XSCF, the
processing for waiting for the power-on of the air
conditioning facilities and the completion of
warm-up is omitted.
If the system is not
stopped in Locked mode:
Operation is ignored.
Table 2-5 Functions of the mode switch
Function Mode switch
Locked Service
Start/stop of the system by the
power switch
Only system startup is enabled. A long press
powers off the
system.
Inhibition of break signal
reception
Enabled. Using the setpparmode
command, you can specify whether to
receive break signals or inhibit their
reception for each physical partition.
Disabled
Table 2-5 describes the functions of the mode switch.
2.4 Checking the LED Indications
This section describes the indications given by the system LEDs.
LEDs are mounted on the operation panel on the front of the chassis, on the rear
panel of the chassis, and on each component that can be maintained. If an error
occurs, the LED indication enables you to determine the system that requires
maintenance.
2.4.1 Operation panel LEDs
The three LEDs on the operation panel indicate the operation status of the entire
system. In addition, the LEDs enable you to check the system status by their
Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021 18