Fujitsu Oracle M10-1, Руководство по обслуживанию

Страница: 125 / 254

Table 7-12 Work procedure for system-stopped/cold addition
Item Work procedure Reference
1 Opening the rack door
2 Switching the mode switch on the
operation panel to Service mode
" 5.2 Switching the Mode Switch to Service Mode "
3 Checking the operating condition
of the system and the I/O device
usage status
" 5.3 Checking the Operating Condition and Resource Usage Status "
4 Stopping the system " 5.5 Stopping the Entire System "
5 Removing the power cords " 5.8.1 Removing the power cords "
6 Installing the target FRU When you install a PCI Express card;
" Chapter 8 Maintaining the PCI Express Cards "
When you install an internal disk;
" Chapter 9 Maintaining the Internal Disks "
7 Installing the power cords " 6.1.6 Installing the power cords "
8 Performing a diagnosis test " 6.4 Diagnosing a Replacement FRU "
9 Confirming that there is no
problem with the installed FRU
" 6.7 Checking the FRU Status after Maintenance "
10 Returning the mode switch on the
operation panel to Locked mode
" 6.8 Returning the Mode Switch to Locked Mode "
11 Starting the system " 6.9 Starting the System "
12 Closing the rack door
Note - You can perform the active/hot removal work for an internal disk only in a RAID
7.4 FRU Removal Workflow
This section describes the removal workflow for the following FRUs of the SPARC
M10-1:
- PCI Express card
- Memory
- Internal disk
7.4.1 Active removal
This section describes the workflow for active/hot removal of an internal disk.
References to detailed descriptions are written in the workflow. See any of them as
required.
Chapter 7 Maintenance Flow 111