FUJITSU Storage ETERNUS DX60 S2 Disk storage system User’s Guide -Installation-
80
Copyright 2014 FUJITSU LIMITED
P3AM-5502-05ENZ0
Chapter 5
Setup
This chapter explains how to set up the ETERNUS DX Disk storage system.
5.1
Basic Setup
Use ETERNUS Web GUI to perform a basic setup of the ETERNUS DX Disk storage system.
5.1.1
ETERNUS DX Disk Storage System and PC Terminal Connection
Connect a PC terminal to the ETERNUS DX Disk storage system.
Use the LAN cable (for operation management) to directly connect the PC terminal to the MNT
port of Controller 0 (CM#0) in the controller enclosure.
Refer to
"1.2 Setup Preparation" (page 24)
for LAN connection properties setup information of
the PC terminal.
The ETERNUS DX Disk storage system and the PC terminal must be
connected directly since the network environment of the ETERNUS DX
Disk storage system is set using the PC terminal for the initial setup of the
ETERNUS DX Disk storage system.
Figure 5.1
PC terminal connection for initial setup
•
If the LAN cable from the MNT port of Controller 0 (CM#0) is connected
to network devices, disconnect the LAN cable and then connect it to the
PC terminal.
•
If the LAN cable from the MNT port is connected to Controller 1 (CM#1),
disconnect the LAN cable.
PC terminal
LAN port
Controller
enclosure
LAN cable
MNT port of Controller 0 (CM#0)
