6663626 OUTDOOR UNIT INSTALLATION PRECAUTIONS
PLACES WHERE USE PROHIBITED
Places where there is the danger of combustible gas leakage
●
Places where sulfur gas, chlorine gas, acid, alkali, or other matter which effects equipment is
●
generated
Places not affected by heat radiation from other heat sources
●
Places where the air is not stagnant
●
Places where machinery which generates high frequencies is used
●
Ocean beaches and other areas where there is a lot of salt
●
Installation in vehicles, ships, and other conveyances
●
Factory, etc. where voltage fluctuations are large
●
POINTS TO REMEMBER WHEN INSTALLING
1) The set shall be installed at a place which can withstand the weight and vibration of the
outdoor unit
2) To allow maintenance after refrigerant piping, drain piping, and electric wiring connection and
installation, provide an installation service space.
*Installation service space is shown on "3-3.INSTALLATION SPACE"
3) Be careful when installing the set at the following places.
[Installation precautions]
Contents
Countermeasures (Reference)
When installed
near adjacent
houses
Perform installation work so that operating
sound does not disturb the neighbors.
1) Install a soundproof barrier
2) Change the installation site
When there is
the possibility
of strong wind
1) If the outdoor unit is exposed to strong
wind, capacity may drop, frost may form
during heating, and operation may be
stopped by high pressure rise. In addition,
when a very strong wind blows, the fan
may be damaged.
2) When a very strong wind blows, there is
the possibility of the outdoor unit being
toppled over if held only by foundation
bolts
1) Install with the outlet side
1000mm or more away
from a facing wall or fence.
2) Make the outlet direction
and wind direction
perpendicular.
3) Fasten the outdoor unit
using toppling prevention
hardware (procured at the
site).
When snow
accumulates
If the outdoor unit is covered by accumulated
snow, it may not be able to operate.
1) Make the foundation as
high as possible.
2) Perform snow prevention
work.
- (06 - 221) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN
Содержание AIRSTAGE V-II
