Fujitsu AIRSTAGE V-II, Дизайн и технические данные

Страница: 592 / 711

666646 INDOOR UNIT (setting by wired remote controller)
This procedure changes to the function settings used to control the indoor unit according to
„
●
the installation conditions. Incorrect settings can cause the indoor unit malfunction.
After the power is turned on, perform the “FUNCTION SETTING” according to the
„
●
installation conditions using the remote controller.
The settings may be selected between the following two: Function Number or Setting
„
●
Number.
Settings will not be changed if invalid numbers or setting numbers are selected.
„
●
PREPARATION
„ „
2) Turn on the power to the indoor unit.
By turning on the power indoor units initializes EEV, so make sure the piping air- ●
tight test and vacuuming have been conducted before turning on the power.
Also check again to make sure no wiring mistakes were made before turning on
●
the power.
Breaker ON
20A
Indoor
units
Indoor
units
1) If multiple indoor units are connected to a single wired remote controller, make sure to
manually set up the remote controller address (RC AD) on the PCBs of the indoor units.
(Refer to 6-5-3.)
Ex.) When four indoor units are connected
0 1 2 3
Indoor unit Indoor unit Indoor unit Indoor unit
RC AD RC AD RC AD RC AD
Wired
remote
controller
- (06 - 120) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN