FujiFilm PXG4, Инструкции по эксплуатации

Страница: 77 / 158

– 76 –
8
Chapter
PV Input Shift
This function shifts PV input before display.
This is used when combining PV input with other instruments.
• Range: -10% to 10% FS
Setting PV Input Shift
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS
SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to display PvoF ("
PPP PvvvvooooFFFF
").
3
Press the key, then use the keys to
select -5.0 when the bottom part of the display
begins to blink.
PV input shift is set to -5.0°C.
4
Press the key to confirm the setting.
5
Press the key to return to the operation
mode PV/SV display.
PV shift of -5 ° C
before
shift
after shift
0
PV display
100 ° C
95 ° C
input
SV Offset
This function specifies the SV shift.
This is used to eliminate remaining offset when using P
control.
• Controls act on the calculated SV with SV offset.
• Alarm determination acts on the displayed SV without SV
offset.
• Range: -50% to 50%
Setting SV Shift
The following steps explain how to set SV shift by using 7°C
as an example.
1
Press and hold the key to display the setup
mode channel menu ("
ooo
oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to display SvoF ("
SSS SvvvvooooFFFF
").
3
Press the key, then use the keys to
select 7.0 when the bottom part of the display
begins to blink.
SV offset is set to 7.0°C.
4
Press the key to confirm the setting.
5
Press the key to return to the operation mode
PV/SV display.
Caution
The SV value in the PV/SV display shows the set value before
the SV offset is added.