33
4. Adjustment
FinePix F601 Zoom (U/E/EG) SERVICE MANUAL
<Step5>
Follow instructions on the [3.20V Input Screen (Fig.8)],
and adjust BATT_END voltage. Set voltage to
3.20V(+0.02V, -0.00V)
, press the [Enter] key on the com-
puter.
---> The
[5.80V Input Screen (Fig.9)]
is displayed.
<Step 6>
Follow instructions on the [5.80V Input Screen (Fig.9)],
and adjust BATT_HIGH voltage. Set voltage to
5.80V(+0.02V, -0.00V)
, press the [Enter] key on the com-
puter.
---> The
[5.00V Input Screen (Fig.10)]
is displayed.
<STE7>
Follow instructions on the [5.00V Input Screen (Fig.10)],
and adjust BATT_REF voltage. Set voltage to
5.00V(+0.01V, -0.01V)
, press the [Enter] key on the com-
puter.
---> Save the adjusted data to the flash ROM when adjust-
ment is completed normally.
---> The
[Battery Adjustment Complete Screen (Fig.11)]
is
displayed when the adjusted data is saved normally.
<Step 8>
Press the [Enter] key on the computer while in the [Bat-
tery Voltage Adjustment Complete Screen (Fig.11)].
---> The
[Adjustment Select Screen (Fig.4)]
is displayed.
Always select [[F12]: End Setting] to complete adjust-
ment.
[Cautions when completing adjustment]
Cautions for adjustments other than battery voltage
adjustment.
(1) Mode Dial Voltage Adjustment
---> Select Mode Dial Voltage Adjustment from the Adjust-
ment Select Screen, and continue adjustment.
(2) Other than Mode Dial Voltage Adjustment
---> Perform the following after [F12]: End Setting.
1) Remove the [NP-60 battery jig] from the camera.
2) Connect the [Power cable jig] to the camera.
3) Set the camera in the jig mode again.
4) Select an adjustment other than Mode Dial Voltage
Adjustment from the Adjustment Select Screen, and
continue adjustment.
<Fig.8> 3.20V Input Screen
<Fig.11> Battery Adjustment Complete Screen
<Fig.9> 5.80V Input Screen
<Fig.10> 5.00V Input Screen
