Fuji Electric FRENIC-ECO, Инструкция по эксплуатации

Страница: 26 / 246

2-6
„ Fixing the keypad (for models of 30HP for 208V, 40HP for 460V or below)
Remove the terminal block (TB) cover and the front cover. (For the procedure, refer to 2.3.1 “Removing and
mounting the terminal block (TB) cover and the front cover.”)
To fix the front cover and keypad, hold the front cover and the keypad together and tighten the two attached
screws (provided as accessories) from the back of the keypad.
Tightening torque: 6.2lb-in(0.7 N·m)
Figure 2.5 Fixing Multi-function Keypad
2.3 Wiring
Follow the procedure below. (In the following description, the inverter has already been installed.)
2.3.1 Removing and mounting the terminal block (TB) cover and the front cover
(1) For inverters with a capacity of 30HP for 208V, 40HP for 460V or below
„ Removing the covers
To remove the terminal block (TB) cover, first loosen the TB cover fastening screw on it, and put your finger
in the dimple of the terminal block (TB) cover (labeled “PULL”), and then pull it up toward you.
To remove the front cover, hold it with both hands, slide it downward to unlatch. Tilt the front cover toward
you, and pull it upward.
Figure 2.6 Removing the Covers (FRN015F1S-2U)*