Fuji Electric FRENIC-ECO, Инструкция по эксплуатации

Страница: 66 / 246

3-8
3.3.2 Setting up the frequency and PID process commands
You can set up the desired frequency command and PID process command by using and keys on the
keypad.
You can also view and set up the frequency command as load shaft speed by setting function code E48.
„ Setting the frequency command
Using and keys (factory default)
(1) Set function code F01 to "0: Keypad operation." This cannot be done when the keypad is in Programming
mode or Alarm mode. To enable frequency setting by using
and keys, first move the keypad in
Running mode.
(2) Pressing the / key causes the frequency command to be displayed on the LCD Monitor, with the
lowermost digit blinking.
Figure 3.6 Setting the Frequency Command in Local Mode
(3) If you need to change the frequency command, press the / key again. The new setting will be
automatically saved into the inverter’s internal non-volatile memory. It is kept there even while the inverter is
powered OFF, and will be used as the initial frequency next time the inverter is powered ON.