3-3
WARNING
The FilterQuick™ FQG30 Series gas fryer is NOT intended to use solid shortening
without a solid shortening kit. Use only liquid shortening with this fryer if a solid
shortening kit is not installed. The use of solid shortening without a solid
shortening kit will clog the top off oil lines.
1.
Fill the frypot with cooking oil to the bottom
OIL LEVEL
line located on the rear of the frypot.
This will allow for oil expansion as heat is applied. Do not fill cold oil any higher than the bot-
tom line; overflow may occur as heat expands the oil. For bulk oil systems see Section 1.9.8 on
page 1-16 in the
FilterQuick™ Controller Manual 819-7206
for instructions to fill the vat from
bulk.
2.
Ensure that the power cord(s) are plugged into the appropriate receptacle(s). Verify that the face
of the plug is flush with the outlet plate, with no portion of the prongs visible.
3.
Ensure that the oil level is at the
top
OIL LEVEL
line when the oil
is at its cooking temperature
.
3.2.2 Lighting the Fryer
1.
Press the controller ON/OFF switch to the OFF position.
2.
Press the controller ON/OFF switch to the ON position and program the controller for normal
cooking temperature.
3.
If the burners fail to light, press the ON/OFF switch to the OFF position and wait 60 seconds.
Repeat step 2.
4.
The fryer will automatically enter the melt cycle mode if the frypot temperature is below 180ºF
(82ºC). (
NOTE:
During the melt cycle, the burners will repeatedly fire for a few seconds, then
Содержание FilterQuick 5FQG30U
Страница 53: ...THIS PAGE INTENTIONALLY LEFT BLANK ...