Frymaster BIELA14-T Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 78 / 82

A–1
BIELA14-T SERIES GEN III LOV™ ELECTRIC FRYER
APPENDIX A: RTI (BULK OIL) INSTRUCTIONS
C.1.1 Bulk Oil Systems
Bulk oil systems have large oil storage tanks,
typically located in the rear of the restaurant,
that are connected to a rear manifold on the
fryer. Waste oil is pumped from the fryer, via the
fitting located on the bottom, to the disposal
tanks and fresh oil is pumped from the tanks,
thru the fitting located on the top, to the fryer
(see Figure 1). Remove the plate exposing the
RTI connection and connect the RTI connection
to the fryer (see Figure 2).
It is necessary that the fryer system be
completely power cycled after changing oil
system type from JIB to Bulk.
Figure 1
Figure 2
The LOV™ fryers, equipped for use with bulk oil
systems, have an onboard fresh oil jug supplied
by RTI. Remove the cap and insert the standard
fitting into the jug with the metal cap resting on
the lip of the jug. The oil is pumped in and out of
the jug through the same fitting (see Figure 3).
Figure 3
The momentary switch used to reset the top off reservoir low
indicator is also used to fill the jug in an RTI system. After pressing
the button to reset the top off system, pressing and holding the
momentary switch, located above the top off reservoir, allows the
operator to fill the jug from the bulk oil storage tank (see Figure 4).
To fill the jug, press and hold the top off reset button until the jug
is full, then release.*
NOTE: Do NOT overfill the jug.
For instructions on filling the vat
from bulk, see Section 5.3.9.
* NOTE: It takes approximately twelve seconds from the time the top off reset button is pressed until the RTI pump
starts. It may take up to 20 seconds before the level in the top off reservoir begins to rise. Typically, it
takes approximately three minutes to fill the reservoir. It takes approximately one minute to fill a split vat
and two minutes to fill a full vat.
Fresh Oil
Connection
Waste Oil
Connection
WARNING
Do not add HOT or USED
oil to a top off reservoir.
NOTE: The instructions in this manual for using a bulk oil system for filling and discarding oil are for an RTI
system. These instructions may not be applicable to other bulk oil systems.
RTI wiring
connection
(behind
Dispose tag).
Figure 4