Frymaster BIELA14-T Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 16 / 82

3–3
Shutdown
1. Place the controller ON/OFF switch in the OFF position to turn the fryer off.
2. Filter the oil and clean the fryers (See Chapters 5 and 6).
3. Clean the filter pan and replace the filter paper or pad. Do not leave solid shortening
in the filter pan over night.
4. Place the frypot covers on the frypots.
3.2 Operation
This fryer is equipped with M4000 controllers (illustrated right). Refer to the M4000
Controller Operating Instructions in Chapter 4 for the controller programming and operating
procedures.
Refer to Chapter 5 of this manual for operating instructions for the built-in filtration system.
3.3 Low Oil Volume Automatic Refill
When the Low Oil Volume (LOV™) system is
in place on the fryer, the frypot oil levels are
continually checked and topped off as
necessary from a reservoir in the cabinet.
The reservoir holds a 35-pound box of oil.
In a typical operation this will last
approximately two days.
Components of the system are annotated at the
right (see Figure 1).
NOTE: The system is intended to top off the
frypots, not fill them. The frypots will require
manual filling upon startup and after deep clean
(boil-out) unless a bulk fresh oil system is used.
Special Cap: Has plumbing
attached to draw oil from the
reservoir to the fryer vats.
Figure 1
Jug In Box (JIB):
The JIB is the
reservoir for the oil.
JIB (Jug In Box) Reset
Switch:
Resets the yellow
indicator after an oil change.
3.3.1 Prepare the System for Use
Once the fryer is positioned under the hood
install the JIB (Jug In Box) basket shipped in the
accessories pack (see Figure 2). If using the solid
shortening option see Appendices B and C.
Figure 2
3.3.2 Changing the oil reservoir
Remove the original lid from the oil container and foil liner. Replace with the provided cap, which has connected
suction hardware. Ensure the feeder tube from the cap reaches to the bottom of the oil container.
Place the oil container inside the cabinet and slide it into place (as shown on the following page). Avoid catching the
suction hardware on the cabinet interior as the container is placed in the fryer.
The system is now ready for operation.
M4000 CONTROLLER