Frymaster BIELA14-T Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 70 / 82

7-1
BIELA14-T SERIES GEN III LOV™ ELECTRIC FRYER
CHAPTER 7: OPERATOR TROUBLESHOOTING
7.1 Introduction
This section provides an easy reference guide to some of the common problems that may occur during the
operation of this equipment. The troubleshooting guides that follow are intended to help correct, or at least
accurately diagnose, problems with this equipment. Although the chapter covers the most common problems
reported, you may encounter problems that are not covered. In such instances, the Frymaster Technical Services
staff will make every effort to help you identify and resolve the problem.
When troubleshooting a problem, always use a process of elimination starting with the simplest solution and
working through to the most complex. Never overlook the obvious – anyone can forget to plug in a cord or fail to
close a valve completely. Most importantly, always try to establish a clear idea of why a problem has occurred. Part
of any corrective action involves taking steps to ensure that it doesn’t happen again. If a controller malfunctions
because of a poor connection, check all other connections, too. If a fuse continues to blow, find out why. Always
keep in mind that failure of a small component may often be indicative of potential failure or incorrect functioning
of a more important component or system.
Before calling a service agent or the Frymaster HOTLINE (1-800-24-FRYER):

Verify that electrical cords are plugged in and that circuit breakers are on.
 Have your fryer’s model and serial numbers ready to give to the technician assisting you.
DANGER
Hot oil will cause severe burns. Never attempt to move this appliance when filled with hot oil or to transfer
hot oil from one container to another.
DANGER
This equipment should be unplugged when servicing, except when electrical circuit tests are required. Use
extreme care when performing such tests.
This appliance may have more than one electrical power supply connection point. Disconnect all power
cords before servicing.
Inspection, testing, and repair of electrical components should be performed by an authorized service agent
only.