Fronius 8,045,368, Руководство по эксплуатации

Страница: 42 / 60

40
Setting the
oscillation
1. Set the "Start LEFT / STOP / Start RIGHT" toggle switch to the
"STOP" (0) position.
Oscillation makes it possible to produce broad weld seams. The oscillation parameters
determine the appearance and quality of the weld seam. Observe the following proce -
dure:
2. Turn the "Control unit ON/OFF" toggle switch to the "ON" position
4. Observe the oscillation motion and set the following oscillation
parameters:
5. Turn the "Oscillation mode MANUAL / OFF / AUTOMATIC" toggle
switch to the "AUTOMATIC" position. Oscillation starts at the same
time as the program sequence.
IMPORTANT! If the driving vehicle has been configured for interval
welding, the oscillation motion is only active in the welding seg -
ment. In the pause segment, during crater filling and back-filling,
the oscillation unit stops and waits in the middle position.
3. Start trial run. Turn the "Oscillation mode MANUAL / OFF / AUTO -
MATIC" toggle switch to the "MANUAL" position.
dwell time left [ s ]
dwell time right [ s ]
Oscillation path [mm]
Oscillation speed [mm]
6. Start the welding process. Turn the "Start LEFT / STOP / Start
RIGHT" toggle switch to the desired setting. To stop the process
early, turn the switch to the "STOP" (0) position.
7. Make any necessary corrections (welding torch position, direction
of travel, traversing speed, oscillation motion, etc.).
Oscillation option