Fronius 8,045,368, Руководство по эксплуатации

Страница: 39 / 60

37
Total path programming: The total path can be divided into segments (welding seg -
ments, pause segments). In the application illustrated, the welding segments are 10 cm
in length and the pause segments are 5 cm in length. In order to ensure that all the requi-
site welding segments are covered, always take note of the total length of all welding and
pause segments when programming the total path. The illustration below demonstrates
the setting options and their outcomes.
End
End
End
End
10 cm
Welding
S1 S2 S3 S4 S5 S6 S7 S8 S9
Pause Pause Pause Pause
Welding
Total path = 43 cm
Total path = 47 cm
Total path = 45 cm
Total path = 54 cm
Total path = 55 cm
Welding Welding Welding
5 cm 5 cm 10 cm
(1)
(2)
(2)
(3)
(1) Setting 1
Total path e.g. 43 cm or 45 cm: If the total path finishes in a pause segment (S6),
the driving vehicle stops after completing the last welding segment (S5). The
outstanding path in the subsequent pause segment is no longer traversed. "End"
appears on the control panel display.
(2) Setting 2
Total path e.g. 47 cm or 54 cm: If the total path finishes in a welding segment (S7),
the driving vehicle stops immediately upon completion of the programmed total
path. "End" appears on the control panel display.
(3) Setting 3
If the total path is e.g. 55 cm ... the vehicle stops immediately upon completion of
the programmed total path (55 cm) or as soon as the last welding segment has
been traversed (S7). "End" appears on the control panel display.
Interval
welding
(continued)