Fronius 8,045,368, Руководство по эксплуатации

Страница: 30 / 60

28
1. Undo the fastening screws (a)
2. Extend the guide wheels (b) to the desired length. To ensure that the driving vehicle
keeps to the chosen direction, the extended guide wheels must be extended by at
least 5 - 10 mm (see diagram).
3. Tighten the fastening screws (a)
Adjusting the guide wheels
Adjusting the
guide wheels
5 - 10 mm
Direction of travel
(a) (a)
(b)
(b)
Before positioning the driving vehicle, check the following:
- The surface of the workpiece must be clean (no sand, swarf etc.)
- The bottom plate of the driving vehicle must be free of objects which can be attracted
by the magnet
- The rubber elements of the drive wheels must be undamaged and free of swarf
- The guide wheels must be clean, undamaged and free of welding spatter
Check the sur-
face of the work-
piece and the
driving vehicle to
ensure they are
clean
1. Place the driving vehicle on the work -
piece. Adjust the side guide wheels to
the workpiece.
2. If necessary, correct the position of the
guide wheels
3. Set the permanent magnet control
lever to the "ON" position
Activate the permanent magnet
Position
the driving vehi-
cle and activate
the permanent
magnet
WARNING! The activated permanent magnet poses a risk of injury
With the permanent magnet activated, there is a danger of injury to the fingers
when positioning the driving vehicle. The driving vehicle must only be posi -
tioned with the permanent magnet deactivated.
- Turn the control lever to the "OFF" position
- Only hold the driving vehicle by the handle and not by the bottom plate