Fronius 8,045,368, Руководство по эксплуатации

Страница: 36 / 60

34
Continuous
welding
(continued)
8. Press the "SELECT / ENTER" button; all signal lamps go off. Parameter entry is
deactivated and the current traversing speed of the driving vehicle is displayed (e.g.
"60.0 cm/min").
9. Turn the "Welding ON/OFF" toggle switch to the "ON" position.
10. Turn the "Start LEFT / STOP / Start RIGHT" toggle switch to the desired setting and
start the welding process. To stop the process early, turn the switch to the "STOP" (0)
position.
IMPORTANT!
The welding process stops automatically once the relevant limit
switch on the driving vehicle is actuated.
5. Press the "+ / -" buttons and set the desired end-crater time (e.g. "2.5 s").
Press the "SELECT / ENTER" button to accept the value. The next parameter is
selected.
6. Press the "+ / -" buttons and set the desired back-fill time (e.g. "1.0 s").
Press the "SELECT / ENTER" button to accept the value. The next parameter is
selected.
7. Press the "+ / -" repeatedly until " InF " appears in the display. This display appears
after the value „999“ and before „1“. To change the display more quickly, press the
“+” or “ -” button for 2 seconds.