Frigidaire LGUB2642LF2, Руководство по обслуживанию

Страница: 107 / 187

6-1
Component Teardown
COMPONENT TEARDOWN
This section explains how to access and remove components from an Electrolux French Door Bottom Freezer Refrigerator,
and has been arranged in such order as to simulate the sequence in which components would need to be removed in
order to gain access to other components. When following a component removal procedure, it may be necessary to
reference another component removal procedure outlined earlier in this section.
IMPORTANT NOTE: Before continuing, please take note of the WARNINGS and CAUTIONS below.
- IF IT IS NECESSARY TO REMOVE A FRENCH DOOR BOTTOM FREEZER REFRIGERATOR UNIT FROM ITS INSTALLATION,
USE PROPER LIFTING TECHNIQUES AS UNITS ARE HEAVY AND COULD FALL RESULTING IN SERIOUS INJURY OR DEATH.
PULLING A UNIT FROM ITS INSTALLATION SHOULD ONLY BE PERFORMED BY A TRAINED AUTHORIZED SERVICE
TECHNICIAN OR INSTALLER.
- TO AVOID ELECTRIC SHOCK, POWER TO A FRENCH DOOR BOTTOM FREEZER REFRIGERATOR MUST BE DISCONNECTED
WHENEVER ACCESSING AND/OR REMOVING COMPONENTS POWERED BY ELECTRICITY OR COMPONENTS NEAR OTHER
ELECTRICAL COMPONENTS.
- AFTER SERVICE IS COMPLETED, BE SURE ALL SAFETY-GROUNDING CIRCUITS ARE COMPLETE, ALL ELECTRICAL
CONNECTIONS ARE SECURE, AND ALL ACCESS PANELS ARE IN PLACE.
- IF UNIT WAS USED PRIOR TO SERVICE, THE COMPRESSOR ASSEMBLY WILL BE HOT. WEAR PROTECTIVE GLOVES
AND THE APPROPRIATE SAFETY GEAR WHEN WORKING WITH COMPRESSORS.
- IF REMOVING A DOOR OR DRAWER FROM A UNIT, REMEMBER THAT DOORS AND DRAWERS ARE HEAVY. IF THEY
WERE TO FALL, THEY COULD CAUSE SERIOUS PERSONAL INJURY.
- Metal edges may be sharp. Use caution and wear appropriate safety equipment when servicing evaporators and
condensers to avoid personal injury.
- If working in the compressor area, remember that compressor and tubing may be hot.
When handling and or replacing a control board it is important that the technician have a wrist ground strap on and con-
nected to the cabinet or another grounding position to prevent static electricity from damaging the board.