Fri-Jado Deli Multisserie, Руководство по обслуживанию

Страница: 31 / 132

REMOVAL AND REPLACEMENT OF PARTS
Page 31
Service Manual Deli Multisserie form 9123667 rev. 20220317
2 2
44
99
10 10
55
66 88
1. Clean and degrease the “old” spacer [254]
or take a new one.
2. Clean and degrease the contact-surface
from the spacer on the inner oven wall.
3. Mount the mounting plate half-fastened
on the spacer (3 bolts M5x10 serrated).
4. Put a layer of heat resistant sealant
(340°C) on the contact-surface.
5. Push the spacer on its place (1 bolt centre-
up !) against the inner oven-wall and
mount the 4 blolts half-fastened (M5x10
serrated).
6. Mount the 3 bolts on the inside and fasten
them (M5x18).
7. Remove the redundant sealant with a
cloth or the like.
8. Now fasten the 7 bolts at the rear.
ASSEMBLING THE BLOWERS
ASSEMBLING THE SHAFT TRANSIT SPACER.
9. Carefully clean the blower shaft.
File away the damaging on the blower
shaft caused by the socket set-screw of the
adjustingring in. (this only applies when
the old shaft seal was from a previous mo-
del)
10. Put the blower motor on its position and
place the nuts. Not tight!! (M6 serrated
black).