Fri-Jado Deli Multisserie, Руководство по обслуживанию

Страница: 26 / 132

PROGRAMMING INSTRUCTIONS
Page 26
Service Manual Deli Multisserie form 9123667 rev. 20220317
*
“Yes” in case the unit has a 3-way valve.
“No” in case the unit has a grease separator.
The first units do not have a feedback on the drain valve. This is a signal that tells the processor that the valve is
in the good position.
To find out if your unit has it, please follow the following steps:
Go to the I/O test menu (last item in the service menu) and enter it.
Go to the MFMB inputs item and press OK.
If the X30-31 or X16-17 item is “1” your machine has the feedback installed. The “drain feedback” parameter
should be “yes”.
If both X30-31 and X16-17 are “0” your machine does not have the feedback installed, the “drain feedback”
parameter should be “no”
**Only visible of “condensor” is put on “yes”.
Level 1 Level 2 Level 3 Default Possibilities
Sensor offset 0°C -5°C - +5°C
drain feedback yes* no-yes
Clean timing Adding clnr T21 8 min. 0 - 10
Dry soak T22 10 min. 0 - 30
Wet soak T23 0 min. 0 - 60
Rinsing T34 4 min. 0 - 10
Drying T25 4 min. 0 - 60
clean temp Steam Temp 60°C/ 140°F 5°C - 120°C (41°F - 248°F)
Dry Temp 70°C/ 158°F 5°C - 120°C (41°F - 248°F)
Clean Temp 65°C/ 149°F 5°C - 120°C (41°F - 248°F)
cold flush time** 25 10 - 60
rinse option no yes - no
complete cleaning yes no - yes
delete all programs yes - no
PID factors P 100 0 - 100
I 5 0 - 100
D 100 0 - 500
iMax 100 10 - 300
Relay actions 80 16 - 160
Energy Volts 230 1 - 260
Model M_Bake none
Pressure no no - yes
I/O test Read the inputs and set the outputs
Ignore errors no no - yes
save HACCP log save haccp on USB
save parameters save parameters on USB
load parameters load parameters from USB