6. Isolator cartridges
SELECT and INSTALL as
necessary
7. Payload mounting location CONFIGURE as necessary
To set up ALTA X for flight, remove it from the case, and remove the prop straps.
Unfold the booms by placing one hand on a boom and one hand on the airframe and then
unfolding the boom. The boom linkage system will unfold all booms at once. Once unfolded,
be sure to latch each side of the locking ring. These latches are redundant and ensure that
the booms stay in the open flight position during flight.
Check that the receivers and the electrical connectors that attach to the receivers are secure.
For information on installing isolator cartridges and setting up payload mounting locations,
refer to the Isolator Cartridges and Configuring GroundView or SkyView sections of this
manual.
Before Starting
1. Payload
SECURED
2. Isolator Cartridges
VERIFY SECURE
3. Propellers
CHECK CONDITION, VERIFY TIGHT
4. Propeller Hubs
VERIFY SECURE
5. Motors
CHECK CONDITION
6. Radio Controller
ON, VERIFY TX BATTERY
7. Radio Controller Model
SELECT
8. Aircraft Placement
AWAY from people and obstacles
9. Battery Pack Voltage
VERIFY ABOVE 48V
10. Battery Packs
SECURE
11. Battery Leads
CHECK CONDITION and CONNECT
12. Aircraft
KEEP STATIONARY
