1. Remove two screws holding closeout door, remove closeout door
2. Install DC-DC converter using supplied button-head screws
3. Route & connect XT30 connector to inside of the power expansion board
4. Route XT60 connector to desired location
{% hint style="info" %} The internal XT30s of the power expansion board share the same
10A fuse as J1. {% endhint %}
Operation Notes
The power converter will power on automatically as soon as the battery is connected on the
aircraft.
The power converter will power on automatically as soon as the battery is connected on
the aircraft.
The converters have overcurrent & short circuit protection, and will restart
automatically upon clearing of overcurrent/short circuit condition.
{% hint style="warning" %} Caution! The DC-DC converter heatsink may get very hot when
drawing power. {% endhint %}
Procedures
Unpacking and Setup
1. Aircraft
REMOVE from case
2. Prop straps
REMOVE
3. Booms
UNFOLD
4. Ring latches
LOCK
5. Receivers and wiring
CHECK