Autoland) may vary depending on the type of radio. Refer to the
section of this manual for additional details.
Installation of Futaba Radio
1. Locate the bay used for receiver installation (between booms 2 & 3 )
2. Remove quick release door with radio wires:
3. Plug signal wire into receiver.
4.
If using telemetry, plug the telemetry wire located in the bay between
booms 2 & 3 into the opposite side of the receiver.
5. Feed receiver antenna through bottom of chassis via the plastic ferrule.
6.
Secure receiver using the provided double-sided tape to inside of
receiver housing.
Replace the quick release door.
7. Route antenna wires into the two antenna tubes below ALTA X chassis.
8. Repeat installation process for dual receivers (if applicable).
Installation of Spectrum Radio
1. Locate the bay used for receiver installation (between booms 2 & 3 )
2. Remove quick release door with radio wires:
