Franklin Electric 5870205003C, Руководство пользователя

Страница: 15 / 136

SubDrive/MonoDrive Connect
15
Fuse/Circuit Breaker and Wire Sizing
The Listed fuse/Listed circuit breaker size and maximum allowable wire lengths for
connection to the SubDrive/MonoDrive are given in the following tables:
Model Family
Listed Fuse /
Listed Circuit
Breaker Amps
Nominal
Input
Voltage
AWG Copper Wire Sizes, 167 °F (75 °C) Insulation Unless Otherwise Noted
14 12 10 8 6 4 3 2 1 1/0 2/0
MonoDrive C
15 208 80 125 205 315 500 790 980 1290 1635 - -
15 230 95 150 250 385 615 970 1200 1580 2000 - -
SubDrive15 C
15 208 70 110 185 280 450 710 880 1160 1465 - -
15 230 85 135 225 345 550 865 1075 1415 1795 - -
MonoDriveXT C
20 208 - 85 140 220 345 550 680 895 1135 - -
20 230 - 105 175 265 425 670 835 1095 1390 - -
SubDrive20 C
20 208 - - 115 180 285 450 555 730 925 - -
20 230 - 85 140 220 345 550 680 895 1130 - -
SubDrive30 C
25 208 - - 95 145 235 370 460 605 765 - -
25 230 - - 115 180 285 455 560 740 935 - -
SubDrive50 C
40 208 - - - - 150 235 295 385 490 610 735
40 230 - - - 115 185 290 360 470 600 745 895
Table 1: Circuit Breaker Sizing and Maximum Input Cable Lengths (in Feet)
Based on a 3% voltage drop
XXXX
Highlighted Numbers denote wire with 194 °F (90 °C) insulation only.
NOTE:
Not to be used on a Ground Fault Circuit Interrupter (GFCI). If using an externally regulated generator, verify that the
voltage, Hertz and idle speed are appropriate to supply the drive.
Service Entrance
Panel
GND
GND
Use the service
entrance panel
ground ONLY.
DO NOT run ground wire separate.
Motor ground wire MUST be bundled with motor wires.
Pump
Motor