Pro
Website
38
7.15 Update Receiver
After each transmitter update the receiver will need to be updated.
Setup:
Touch [Update Receiver]:
•
Some receivers such as GMr need to be updated with "Flysky Assistant".
If the transmitter has successfully coded and the connection is established, if the
receiver is the latest version, a pop-up prompt will appear [The current version is the
new version, no upgrade is required! ]. If the transmitter is an old version, a pop-up
prompt [Are you sure to update the receiver? ]. Click [Yes] to update the receiver;
If the receiver and the transmitter are not connected, then enter the receiver selection
interface (FGr8B/FGr4B needs to be placed upright when in use), check the receiver to be
connected and pop up a prompt [Please connect XX or enable XX enter the mandatory
update mode] Click [OK]!
After entering the update, When the progress is 100%, the update is successful.
Note: You must update the high frequency before updating the receiver.
BInd
The steps of the forced update of the receiver are as follows:
1. Press the bind key on the receiver. Then, release the bind key after the indicator flashes three times and goes
off ten seconds later than the power-on.
2. Power on the transmitter and select [Update Receiver]. Click the right side
of the corresponding receiver.
Select "OK" on the pop-up box. Click [Update] to enter the update state.
3. The update is complete. The indicator flashes slowly.
Bind
